Day 16 - Applying varnish to the deck

-
In the steps below I am already into applying varnish. Not photographed were the steps involving applying tape to the toerails but you can see the end result. I have chosen to varnish the deck up to the rails and then paint the rails the same color as my hull - this is more like what is done on real sailboats. Here is just the first coat of varnish applied:








I applied several coats in one day and built up the finish to my liking. I used the varnish kit that came from Tippecanoe. It works fine but is a bit too glossy for my taste. The finish will get dulled back a bit at a later finishing stage. 

Comments

Post a Comment

Popular posts from this blog

Introduction — Why do a build log?

-
I recently received the T37 sailboat model, from Tippecanoe Boats, for Father's day. The T37 assembly instructions are exceptionally detailed and Tippecanoe has clearly put a lot of care and thought in to the product and the whole process. Hopefully the addition of my assembly photos will be a useful complement. I encourage everyone to upload as many photos and explanations of your own personal experience, so that others might benefit. I welcome any comments or suggestions you might have. For what it's worth, this will be my first time building a model sailboat - we'll see how it goes. Gary August 30, 2015: Thanks to all of you who have taken the time to review this build log. I have been quite busy with my business, my kids, some real sailing and have not had the time to continue the build for a whole year - crazy how time flies. I have started back on the project now and plan to move through to completion quite quickly. Many posts to follow. I hope you enjoy ...
Read more

Day 4 - Assembling the keel, finishing fairing

-
Image
Day 4 began with preparing the keel for sanding and mounting of the ballast. In preparation for sanding, I marked off the area where the ballast will be positioned so I can more easily avoid sanding aggressively in that area. It should remain flat for adhesion to the ballast pieces: Next, I marked the areas of the planned taper for the leading and trailing edges of the rudder. Here the  leading edge [R] is marked ¾ of an inch back and the trailing edge [L] is marked 1.5 inches in. The trailing edge should slope continuously to a fine edge while the leading edge should have start with a fairly fine edge but round off into more of an arc (think about the shape of an airfoil or airplane wing). Racing regulations require that 1-1/2 inches at the top of the keel and 1" at the bottom of the keel maintain at least ¼" in thickness. This area lies a bit forward of the center line giving the rudder chord its familiar airfoil shape. I marked this area off with the ha...
Read more